|
| |
|
+
Constructed of T-3 2024 Aluminum
tubing & billet T-6 6061
+ All hardened and
zinc/stainless hardware
+ Pivot
area's are sealed
+ Zerk
fitting's installed in the pivot area to reduce
possible "seizing"
+ Dual
Rate cartridges (PDS) Progressive Dampening System
+
Lightweight
+ Modular
+
Rebuildable
+
Anodized
+
SOFT BARS are only suited for aftermarket ATV
steering
stems
and certain stock ATV steering
stems.
+ Weighs
4.5 pounds
+ Bar
pads are all gloss black with our ATV Four Play
Logo.
|
ATV
Four-Play
SOFT BAR GEN II
After
several months of testing on mini quads and big
quads, ATV Four-Play constructed a means
that greatly reduces the harsh impacts
on youth rider’s upper body commonly associated with
ATV riding.
The idea was to design a handle bar assembly
specific for ATV use.
ATV
Four-Play also wanted
a system that would conform to the rider’s ever
changing body position.
Normally the youth rider’s arms, wrists and upper
body’s are not fully developed to handle these
impacts. With that in mind the youth rider's
weight being much lighter, it is necessary to have
the bars pivot with less downward force. So the with
our design it is possible to make the resistance
"lighter on the top" of the travel.
|
|
ATV
Four-Play
SOFT BARS use a (PDS) Progressive
Dampening System. This system uses a dual rate
vertical cartridge installed in the upright pivot
assembly. This fully adjustable system allows
for light resistance at the beginning of the travel
continuing to a heavier resistance at the end of
travel.
ATV Four Play’s SOFT BARS
will initially be offered in (1)
style which is very similar to the CR HIGH. The
sweep is at 12 degree's back.
|
|
|
|
New!!!
Black, Orange, Red and Orange/Black |
 |
|
|
The
SOFT BARS are only suited for
aftermarket ATV steering stems and certain models of
OE steering stems. The SOFT BARS
cannot be used on a motorcycle. The reason is
ATV Four-Play do
not use the "clamp tube" that is secured to
motorcycle by a handlebar clamp. SOFT
BARS bolt directly to the ATV steering
stem and does
not require
the "traditional" handle bar clamp arrangement or
the 1 1/8"
adapters.
|
|
|
